Messer Cutting & Welding K4 Operations Instructions download pdf (Page 23)

2 Description of the system components

2/11

2.4.2 M110: digital V / A meter with hold function (optional for M100

and M200)

Fig. 2/9; Control panel of M110 digital voltage and power display

Digital welding current display

Digital welding voltage display

2.5 The remote controls (optional, only in combination with M200)

Only the remote controls described in these operating instructions should be connected!

Remote controls must only be connected or removed when the machine is switched off!

The welding machine detects the remote control automatically after being switched on.

The machine must be equipped with the option remote control potentiometer connection

option

2.5.1 Manual remote control RM

• Connect remote control to remote control socket (see 2.2).

Rotary dial for the infinite adjustment of:

• Wire feed speed correction

• Wire feed speed 1 -20m/min

(Selector switch

chap. 2.3.1 in

manual position)

• Connector plug (19-pole) with 5-metre

connection cable.

2.5.2 Manual remote control on the welding torch (option, in preparation)

2.6 Mechanised welding interface (optional, only in combination with

M200)

The welding current sources feature a very high standard of safety.

This safety standard is also retained when peripheral equipment is connected for automatic

welding if this peripheral equipment fulfils the same criteria, particularly with regard to their isolation

from the mains supply.

This is ensured when transformers conforming to VDE 0551 are used.

All interface contacts described below in this chapter can be loaded with a maximum of:

100mA +15V/-15V

The following signals are available on the remote control socket:

• Start / Stop power source

• Power-flow signal I > 0

• Control voltage to regulate wire feed speed

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 89 90

No comments

Messer Cutting & Welding K4 Operations Instructions Page 23