Messer Cutting & Welding K4 Operations Instructions download pdf (Page 36)

4 Description of control M200 / M210 (optional)

4/5

4.4.2.3 Short-circuit in any welding operation (remote ignition)

Both LEDs lit with short, fast flashes. The machine can, however weld normally. (The values from

the previous welding operations are used.) The LEDs go out as soon as the torch trigger is pressed.

4.5 Wire feed speed correction

4.5.1 Wire feed speed correction via remote control (optional)

The settings for correcting the WF speed (one-dial operation) and for the WF speed (manual

operating mode, two-dial operation) can be made independently of the setting on the control.

4.5.2 Wire feed speed correction via remote control on the welding torch

(optional)

• Connect the welding torch with the potentiometer to the central connection on the welding

machine.

• Plug the control lead on the torch into the remote control socket.

The settings for correcting the WF speed (one-dial operation) and for the WF speed (manual

operating mode, two-dial operation) can be made independently of the setting on the control.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 89 90

No comments

Messer Cutting & Welding K4 Operations Instructions Page 36